C14 Power-Assist Tuning Parameters Setting - KUNTENG KT-LCD8H User Manual

The recommended value of C13 is 1; other values need to be chosen with caution for
use.
Be sure to note: the higher is the braking intensity level, and the braking strength
will be greater, the greater damage to the motor shaft accordingly.
After finishing the parameter setting of C13, press
C14 parameter setting interface.
○

C14 Power-assist tuning parameters Setting

Enter C14 parameter setting interface, C14 parameter bar flashes.
C14 is the parameters of power-assist tuning setting, with the default value of 2. The
power-assist is between1-4 gear, and it is invalid until P3 equals to 1. The setting range 1-3,
and press (UP) button or
C14 parameter definition table:
C14 Value
After finishing C14 parameter setting, hold
set values and enter C1 parameter setting interface again. Or hold
for about 2 seconds to exit C parameter setting environment and return to the display 1.
1. L1 parameters are applicable to the automatic under voltage controller. The
default of the factory L1 is 0.
1.1 L1=0, the automatic undervoltage controller can automatically select the under
ELECTRIC BICYCLE METER KT—LCD8H Product User Manual
C14 parameter setting interface
(DOWN) button for short to make selection.
1
2
3
LCD8 instrument L parameter definition
(SW) button for short to enter
Assist strength of intelligent pedal motor
Weak assist strength of motor
General assist strength of motor
Stronger assist strength of motor
button (SW) shortly to save current
- 36 -
efficiency
button (SW) long