L3 Parameters Setting; Exit C Parameter Setting - KUNTENG KT-LCD10YN User Manual

ELECTRIC BICYCLE METER KT—LCD10YN Product User Manual
When L2=0, P1 parameter is set as the calculated value.
When L2=1, P1 parameter is set as a half of the calculated value.
After finishing L2 parameter setting, press
value and then enter L3 parameter setting interface.
○
L3 Parameter setting
L3 parameter is applicable to the dual mode controller. The default of the factory
is 1.
When L3=0, the controller will activate Non-Hall model only when the Hall
sensor in the motor fails
When L3=1, the controller will choose the proper model to use according to
the controller system optimization.
After finishing L3 parameter setting, hold
exit L parameter setting environment and return to the display 1
○
Exit Parameter Setting
Among the fourteen C parameter settings, when each parameter setting is completed,
if held button (SW) long for about 2 seconds, all can exit the setting environment
and return to display 1, meanwhile, the current set parameters would be saved.
Under each parameter setting interface, if there's no button operation on the meter for
button (SW) to save the current
button (SW) for about 2 seconds to
- 37 -