Metric And Imperial Units; Exit General Project Setting - KUNTENG KT-LCD10H User Manual

ELECTRIC BICYCLE METER KT—LCD10H Product User Manual
current set specification and enter into the next setting.
○

Metric and Imperial Units

After finishing the wheel diameter setting, enter into the metric/imperial units setting
interface, and then the speed and mileage unit flash. Press
button (DOWN) to make sync selection of three metric/imperial units as speed, mileage,
and the environment temperature.
Definition Table of Metric/Imperial Units：
Riding speed
Total distance
Environment
temperature
Under the metric/imperial units setting interface, if there's no button operation
on the meter for more than 1 minute, and then the meter will automatically return to
display 1, and the original set units will be saved.
After finishing the metric/imperial units setting, press
current set values, and then speed and mileage units stop flashing. Press
again, and the meter will enter into the maximum riding speed interface again, or hold
button (SW) long for about 2 seconds to exit the general project setting environment
and return to display 1.
○

Exit General Project Setting

Setting Interface of Metric/Imperial Units
Display
℃ Temperature
Metric
Km/H
Km
℉ Fahrenheit
- 19 -
button (UP) or
Imperial
MPH
Mil
button (SW) to save the
button (SW)