C14 Power-Assist Tuning Parameters Setting; L 1 Pa Ra M E Te Rs Se T T I Ng; Exit Parameter Setting - KUNTENG KT-LCD4 User Manual

value and then press
○

C14 Power-assist tuning parameters Setting

Enter C14 parameter setting interface, C14 parameter bar flashes.
C14 is the parameters of power-assist tuning setting, with the default value of 2. The
power-assist is between1-4 gear, and it is invalid until P3 equals to 1. The setting range 1-3,
and press (UP) button or
C14 parameter definition table:
C14 Value
After finishing C14 parameter setting, hold
seconds to exit C parameter setting environment and return to the display 1.
○

Exit Parameter Setting

Under each parameter setting interface, if there's no button operation on the meter for
more than 1 minute, and then the meter will automatically return to display 1, and the
original parameters will be saved.
L Parameter Setting
○
L1 Parameter setting
ELECTRIC BICYCLE METER KT—LCD4 Product User Manual
button (DOWN) to enter C14 parameter setting interface.
C14 parameter setting interface
(DOWN) button for short to make selection.
1
2
3
Assist strength of intelligent pedal motor
Weak assist strength of motor
General assist strength of motor
Stronger assist strength of motor
button (SW) long for about 2
- 39 -