To Remove And Replace The Hard Disk Drive - Keysight Infiniium 9000 Series Service Manual

To remove and replace the hard disk drive

Use this procedure to remove and replace the hard disk drive. When necessary,
refer to other removal procedures. The graphics in this chapter are representative
of the oscilloscope at the time of this printing. Your unit may look different.
1
2
3
4
Infiniium 9000 Series Oscilloscopes Service Guide
Disconnect the power cable and remove the rear cover.
Open up the acquisition chamber by removing the sheet metal that separates
the motherboard section from the acquisition board section (refer to the
Acquisition Assembly Removal section for instructions on how to do this).
The hard drive is attached to the under side of this piece of sheet metal.
Disconnect the SATA cables from the hard disk drive, remove the screws
attaching it to the sheet metal, and remove it from the oscilloscope.
These are the SATA cables you need to
disconnect from the hard disk drive
Replacing Assemblies
Hard disk drive
5
123