To Remove And Replace The Hard Disk Drive - Keysight 90000 X Series Service Manual

Chapter 5: Replacing Assemblies

To remove and replace the hard disk drive

To remove and replace the hard disk drive
Use this procedure to remove and replace the hard disk drive. When necessary,
refer to other removal procedures. The graphics in this chapter are representative
of the oscilloscope at the time of this printing. Your unit may look different.
Disconnect the power cable and remove the cover and top plate as described
1
previously.
Disconnect the cables connected to the hard drive.
2
Remove the four M3 screws shown below. Tighten to 5 in- lbs when assembling.
3
Figure 5-41
Remove the M3 screw from the rear panel as shown below.
4
Figure 5-42
104