NEC MultiSync XG85RP-CH Setup Manual page 40

SIGNAL ENTRY
Selecting "POSITION"
This function is used to select the vertical area mode for the
"POSITION-SHIFT" adjustment.
To do this, proceed as follows:
1) Use the CURSOR buttons to select "POSITION" and then
press ENTER.
• The "POSITION" menu will be displayed.
2) Use the CURSOR
"NARROW" and then press ENTER.
• The screen will return to the "SOURCE INFORMATION"
screen.
• Select "WIDE" in normal operation.
Items to select
• WIDE ....... Adjustment area is wide.
• NARROW . Adjustment area is narrow.
NOTE: Selecting "NARROW" may solve problems caused by an
interlace input signal.
Setting "FONT"
This function is used to specify the appropriate font size to the
on-screen message.
To do this, proceed as follows:
1) Use the CURSOR buttons to select "FONT" and then press
ENTER.
• The "FONT SIZE" menu will be displayed.
2) Use the CURSOR
or "SMALL" and then press ENTER.
• The screen will return to the "SOURCE INFORMATION"
screen.
Items to select
• NORMAL . Calculates the appropriate font size with the
vertical scanning lines to display the on-screen
message in the appropriate size.
• SMALL .... Displays the on-screen message in the font size of
75 percent of the NORMAL size.
or button to select either "WIDE" or
or button to select either "NORMAL"
P03/03
POSITION
FONT
APERTURE
SYNC TERMINATION
AFC
P03/03
POSITION
FONT
APERTURE
SYNC TERMINATION
AFC
40
SOURCE INFORMATION
WIDE
NORMAL
MANUAL
LEVEL1
75
NORMAL
P O S I T I O N
W I D E
N A R R O W
SOURCE INFORMATION
WIDE
NORMAL
MANUAL
LEVEL1
75
NORMAL
F O N T S I Z E
N O R M A L
S M A L L