Storing Projector Settings (Automatic Save Feature) - NEC MultiSync XG85RP-CH Setup Manual

Storing Projector Settings (Automatic Save Feature)

You have two options to store projector settings in the memory:
automatically and manually.
NOTE: Storing time is four seconds.
• The Automatic Save Feature mode has been set to DISABLE by
factory. For information on setting, see "Automatic Save Feature"
on page 92.
When the Automatic Save Feature mode is set to "ENABLE",
projector settings will be stored in the projector's memory
automatically.
Settings are stored automatically when any one of the following
procedures is performed:
• The END button is pressed several times to return the adjust-
ment screen to the source screen.
• One input is switched to another.
• The projector is turned off.
• After every 10 minutes of elapsed time.
When the Automatic Save Feature mode is set to "DISABLE",
projector settings can be stored in the projector's memory
manually.
When you try to return the source screen by pressing END
several times, the "STORE ?" menu is displayed.
To manually save settings, proceed as follows:
1. Use the END button to display the "STORE" menu from the
current adjustment screen or menu.
2. Use the CURSOR
"NEW", or "CANCEL" and press ENTER.
Items to select
• CURRENT ------ Overwrites the currently projected signal and
saves the settings. NOTE: An unregistered signal
cannot be stored under the ''CURRENT''
settings.
• NEW ------------ Starting at memory location No.51, this function
saves an unregistered signal as a new signal in
memory.
• CANCEL -------- Does not save settings.
or button to highlight "CURRENT",
CURRENT
19
BEFORE SET-UP
STORE ?
NEW CANCEL