Table of Contents
Advertisement
1 POWER Buttons (ON/OFF)
Press the ON button to turn the projector on when the
projector is in the standby condition (STANDBY and RC
READY indicators lit). Press the OFF button to return the
projector to the standby condition.
2 TEST Button
Press to display the "TEST PATTERN" menu from which
you can select a test pattern.
3 ADJUST Button
Press to display the "ADJUST" menu.
4 OPERATE Button
Press to display the "OPERATE" menu.
5 Backlight Switch
Turns the backlight on and off.
If no button operation is made within 30 seconds with the
Backlight ON, the Backlight will turn off to conserve
battery life.
6 PIC FUNC Button
Press to display the picture adjustment screen.
NOTE: Some function items will not be available
depending on the type of video signal.
7 SOUND FUNC Button
Press to display the VOLUME adjustment screen. You
can adjust the volume of the ISS-6020/ISS-6020G
Switcher.
8 PICTURE (PIC) MUTE Button
Press to mute the picture. Press again to display the
picture. You can also mute the picture by holding down
CTL and pressing PICTURE MUTE buttons. To restore
the picture, holding down CTL and press PICTURE
MUTE again. Or simply press END.
NOTE: When the picture is muted by using CTL and
PICTURE MUTE buttons, even if input is switched to
another or the power is turned off using the remote
POWER OFF button, the mute cannot be canceled.
9 SOUND MUTE Button
Press to mute the sound. Press again to return the sound.
0 DISPLAY Button
Press to turn on or off the on-screen display. Pressing with
CTL eliminates the on-screen display; pressing with CTL
will restore display.
NOTE: Even if the on-screen display may be turned off
with pressing CTL and DISPLAY, any adjustment will
still change the projector's memory settings. This mode
is available even when an input is switched to another or
the power is turned off using the POWER OFF button on
the remote control. On-screen display mute function can
be canceled by turning off the main power.
A FOCUS Button
Press to enter the FOCUS mode.Pressing with CTL will
bring you to the ASTIG adjustment screen.
B STATIC Button
Press to enter the STATIC mode. You can adjust the static
convergence.
C POINT Button
Press to enter the POINT mode. You can adjust the point
convergence.
D TILT Button
Press to enter the TILT, SKEW mode. You can adjust the
tilt and the skew of the projected image.
E BOW Button
Press to enter the BOW mode. You can adjust the hori-
zontal and the vertical bow of the projected image.
Pressing with CTL will bring you to the LINE DISTOR-
TION adjustment screen.
F AMPLIT Button
Press to enter the AMPLITUDE mode. You can adjust the
horizontal width and the vertical height of the projected
image.
G LINEAR Button
Press to enter the LINEARITY mode. You can adjust the
horizontal and the vertical linearity of the projected image.
Pressing with CTL will bring you to the LINEARITY-
BALANCE adjustment screen.
H KEYSTN Button
Press to enter the KEYSTONE mode. You can adjust the
horizontal and the vertical keystone of the projected
image. Pressing with CTL button will bring you to the
KEY-BALANCE alignment screen.
13
PART NAMES AND FUNCTIONS
Advertisement
Table of Contents
