NEC MultiSync XG85RP-CH Setup Manual page 52

ADJUSTMENT
Items to select
• COARSE .............. Coarse adjustment. Number of adjust-
• MEDIUM .............. Number of adjustment zones is 7 x 7.
• FINE ..................... Fine adjustment. Number of adjustment
3) Use the CURSOR or
the point to be adjusted.
• Pressing the CURSOR
Pressing the CURSOR
Pressing the CURSOR
Pressing the CURSOR
bottom.
4) For alignment, hold down the CTL button, then use the
CURSOR buttons to align the pattern. For convergence, hold
down the CTL button and then use the CURSOR buttons to
align the Red or Blue pattern with the Green pattern.
NOTE: For more accurate convergence correction on edges,
perform the amplitude and linearity adjustments before the
POINT convergence adjustment.
6 To end this adjustment, press the END button.
• Whenever the END button is pressed, the menus will sequence
in this order:
"ALIGNMENT" menu
• If the "RETURN USER MODE?" menu appears, use the
CURSOR or button to select either "YES" or "NO" and
then press ENTER. This will exit the ADJUST mode.
Items to select
• YES ......... When you try to enter the ADJUST mode again,
you will need to re-enter your passcode.
• NO ........... When you try to enter the ADJUST mode again,
you will not need to re-enter your passcode.
ment zones is 3 x 3.
points is 13 x 16.
buttons to move the cursor mark to
button moves the cursor to the right.
button moves the cursor to the left.
button moves the cursor to the top.
button moves the cursor to the
"ADJUST" menu Source screen
When the adjustment area
frame is a box type.
When FINE is selected, the adjustment area frame is not displayed.
52
When the adjustment area
frame is a box with one side
open.
: adjustment area frame
: adjustment
RETUR N USER MO DE?
Y E S N O