Password Input; Monitoring- And Analysis Parameters - KEB COMBIVERT R6 Instruction Manual

5.5

Password input

No. Name
CP.00 Password input
Ex works the COMBIVERT R6-S is supplied without password protection, i.e. all changeable
parameters can be adjusted. After parameterizing the inverter can be secured against unaut-
horized access. The adjusted mode is stored.
Enabling the CP-Parameter
(for protection the right password must
be made unrecognizable against unaut-
5.6

Monitoring- and analysis parameters

The following parameters serve for the functional monitoring during operation.
No. Name
CP.01 Status display
The status display shows the actual working conditions of the COMBIVERT.
Status Messages
Feedback active (regeneratoric operation)
rEGEn
Count down of the base-block time, R6-S released
bbL
„no Operation" control release not bridged, modulation switched off
noP
Mains power failure; regenerative operation is further possible, if the disconnecting
nEtoF
time E.nEt (Pn.14) > 0 s
R6-S regeneratve unit in stand-by operation (motoric operation)
Stb
Inspection of phase allocation and synchronization of mains angle
SYn
Error Messages
Error ! Overtemperature choke" , temperature monitoring of the commutation choke
E.dOH
has triggered and the coolong-off period is up.
External Fault, error message by an external unit
E. EF
Error ! Mains, one or more phases are missing
E.nEt
No Over Heat, over-temperature error not present (E.OH), error can be reset.
E.nOH
No Over Load, cooling time after E.OL is up , error can be reset.
E.nOL
Error ! Overcurrent", output current too high or ground fault
E. OC
Error ! Overtemperature", overheating at heat sink (see „technical data")
E. OH
Barring the CP-Parameter
horized access)
Operation of the Unit
r/w
–
FUNC
FUNC
r/w
–
Enter Origin
– ud.01
ENTER
UP
ENTER
UP
Enter Origin
– ru.00
further on next side
GB - 29