Lenovo ThinkSystem DW612S Neptune DWC Instructions Manual page 55

3. If the event persists, ensure the indicated compute node is completely power off, and then reseat it.
(Service technician only)
4. If the event persists, replace the indicated compute node. (Service technician only)
5. If the event persists, please consult with technical service.
• 21050129: Node 2 Inventory: Slot Or Connector, Limit Exceeded was asserted.
The BMC on indicated compure node reports an invalid inventory power whose minimum value higher
than the maximum value.
Severity: Warning
Alert Category: Node - Node event
SNMP Trap ID: 553976105
User Action:
1. Reset the BMC on indicated compute node.
2. If the event persists, reset BMC to default setting to trigger inventory power calculation again.
3. If the event persists, ensure the indicated compute node is completely power off, and then reseat it.
(Service technician only)
4. If the event persists, replace the indicated compute node. (Service technician only)
5. If the event persists, please consult with technical service.
• 2105012A: Node 3 Inventory: Slot Or Connector, Limit Exceeded was asserted.
The BMC on indicated compure node reports an invalid inventory power whose minimum value higher
than the maximum value.
Severity: Warning
Alert Category: Node - Node event
SNMP Trap ID: 553976106
User Action:
1. Reset the BMC on indicated compute node.
2. If the event persists, reset BMC to default setting to trigger inventory power calculation again.
3. If the event persists, ensure the indicated compute node is completely power off, and then reseat it.
(Service technician only)
4. If the event persists, replace the indicated compute node. (Service technician only)
5. If the event persists, please consult with technical service.
• 2105012B: Node 4 Inventory: Slot Or Connector, Limit Exceeded was asserted.
The BMC on indicated compure node reports an invalid inventory power whose minimum value higher
than the maximum value.
Severity: Warning
Alert Category: Node - Node event
SNMP Trap ID: 553976107
User Action:
1. Reset the BMC on indicated compute node.
2. If the event persists, reset BMC to default setting to trigger inventory power calculation again.
3. If the event persists, ensure the indicated compute node is completely power off, and then reseat it.
(Service technician only)
4. If the event persists, replace the indicated compute node. (Service technician only)
5. If the event persists, please consult with technical service.
. 51
Chapter 2 SMM2 events