SSANGYONG Rexton 2004 Service Manual page 1304

Code Fault Contents
52h Communication malfunction of
the driver side airbag
53h Internal fault of the driver side
airbag sensor
54h Passenger side airbag sensor,
open/short to battery voltage
55h Passenger side airbag sensor,
short to ground
56h Communication malfunction of
the passenger side airbag
57h Internal fault of the passenger
side airbag sensor
17h Battery voltage too high
18h Battery voltage too low
1Eh SDM internal fault
(Initialization fault)
1Fh SDM internal fault
Notice
• Use only the scan tool to check the airbag module and the sensing and diagnostic module (SDM). Never
measure the resistance of an airbag module with an ohmmeter. An ohmmeter's battery can deploy the airbag
and cause injury.
• Before testing, disconnect the negative battery cable. Wait 1 minute for the SDM capacitor to discharge. The
capacitor supplies reserve power to deploy the airbags, even if the battery is disconnected. Unintentional
deployment of the airbags can cause injury.
• Do not attempt to repair the supplemental inflatable restraints (SIR) wiring harness. An SIR repair can create a high-
resistance connection which can keep the airbags from deploying when needed, resulting in injury.
AIRBAG SYSTEM
REXTON SM - 2004.4
Check the connection of the driver side airbag sensor connector.
Check the wiring condition of the driver side airbag sensor.
Check the bending of the airbag terminal.
Check the connection of the driver side airbag sensor connector.
Check the wiring condition of the driver side airbag sensor.
Check the bending of the airbag terminal.
Check the connection of the passenger side airbag sensor
connector.
Check the wiring condition of the passenger side airbag sensor.
Check the bending of the airbag terminal.
Check the connection of the passenger side airbag sensor
connector.
Check the wiring condition of the passenger side airbag sensor.
Check the bending of the airbag terminal.
Check the connection of the passenger side airbag sensor
connector.
Check the wiring condition of the passenger side airbag sensor.
Check the bending of the airbag terminal.
Check the connection of the passenger side airbag sensor
connector.
Check the wiring condition of the passenger side airbag sensor.
Check the bending of the airbag terminal.
Check generator output voltage.
Check the battery voltage.
Check the bending of the airbag terminal.
Check generator output voltage.
Check the battery voltage.
Check the bending of the airbag terminal.
Replace the SDM.
Replace the SDM.
Check
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
12-25