SSANGYONG Rexton 2004 Service Manual page 1101

Control by the vehicle speed
The system controls the vent inlet according to the vehicle
speed in order to prevent the exhaust gas of the preceding
vehicle from flowing inside with the vehicle stopping or driv-
ing at low speed. The operation and control condition is
following as;
1. When the vent inlet mode is AUTO and the A/C "ON".
2. When the vehicle keeps to drive at below 10 km/h for
10 seconds and changes the REC mode at stop.
3. If 10 minutes passes after changing the REC mode,
it returns back to the AUTO mode.
Vent outlet Control
Manual control
For pushing the mode switch of AUTO temperature control,
you can select four type of the vent outlets.
When you push the Def switch, it keeps to change to the
defroster mode regardless of the sequence.
A/C SYSTEM
REXTON SM - 2004.4
AUTO Control
A/C Control
Manual control
When you pushed the A/C switch "ON" or the Def switch
"ON", A/C starts to operate.
AUTO control
Basic Control: A/C "ON" has the priority for the initial
operation.
Y220_10C068
Full Cold/Hot Control
When you sets the set temperature to full cold (LO) or full
hot (HI), the system controls the temperature to full cold
or full hot regardless of sensor's detection. For LO, it
becomes A/C "ON", front vent mode, recirculation air, max
blower speed, air mix door close and for HI, A/C "OFF",
floor vent mode, ambient mode, air mix door open.
Y220_10C069
10C-45
Y220_10C070
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN