SSANGYONG Rexton 2004 Service Manual page 1286

Airbag module discard (passenger)
The passenger airbag deployment is the same procedure of the driver's. Remove the glove box instead of the
contact coil and cut two passenger airbag wires.
Refer to "AIRBAG MODULE DISCARD (DRIVER)" in this section for more information.
Airbag module deployment (outside vehicle)
Deploy airbag modules in following situations:
• If the airbag module is removed in the discarded vehicle.
• If the airbag module is replaced due to any fault.
• If an airbag module is damaged during transfer, storage or servicing.
Observe following precaution if the airbag is deployed:
• Deploy the airbags only in an evacuated area. Service mechanics should be at least 10 meters (33 feet).
• Do not connect the voltage source until after having completed all other preparations for the deployment of
the airbags.
• Allow a deployed airbag module or pretensioner to cool for at least 30 minutes before handling.
• If the deployment fails, disconnect the voltage source and wait 5 minutes before approaching the vehicle.
1. Position the airbag module face up, on flat ground outdoors, at least 10 meters (33 feet) from any obstacle
or people.
2. Place a vehicle battery at least 10 meters (33 feet) away from the airbag module.
3. Deploy the airbag module using the deployment tool. If you do not have deployment tool, cut the two
additional wires to the airbag module and strip 13 mm (0.5 inch) of the insulation from the end of the wires
leading to the airbag module.
4. Refer to "DEPLOYED AIRBAG MODULE DISPOSAL PROCEDURE" in this section.
Deployed Airbag Module Disposal Procedure
After deployment, a powdery residue may be on the surface of the airbag. The powder consists primarily of
cornstarch (used to lubricate the bag as it inflates) and by-products of the chemical reaction. Sodium hydroxide
dust (similar to lye soap) is produced as a by-product of the deployment reaction. The sodium hydroxide then
quickly reacts with atmospheric moisture and is converted to sodium carbonate and sodium bicarbonate also
known as baking soda}. Therefore, it is unlikely that sodium hydroxide will be present after deployment. Wear
gloves and eye protection during the disposal procedure.
After deployment, the metal surfaces of the airbag module will be hot. In order to avoid the risk of an injury or a
fire, do not place the deployed airbag module near any flammable objects, and allow the airbag module to cool for
30 minutes before handling. Deploy an airbag or pretensioner before disposing of it.
This includes those in a whole vehicle being scrapped. If the vehicle is still within the warranty period contact the
SsangYong regional service manager for approval or special instructions before deploying an airbag module or
pretensioner.
AIRBAG SYSTEM
REXTON SM - 2004.4
12-7
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN