SSANGYONG Rexton 2004 Service Manual page 1076

10C-20
CHECK AND REPLACEMENT
COMPRESSOR OIL REPLACEMENT
Before Oil Replacement
When any part is replaced or there are a lot of gas leaks in the A/C system, you should add the specified amount of the
oil to keep the approval oil capacity because the oil for lubricating the compressor circulates through the A/C system
during operating the compressor.
Total Oil Capacity
Handling oil
• Be careful that moistures, dusts etc. must not flow into the oil.
• Do not mix with any other material.
• If the oil leaves outside for long time, it's possible to mix it with the moistures and so keep the oil sealed with a
container.
Circulating oil
For checking or adjusting the oil level, set the control unit to full cold and max blower speed with keeping the engine run
at idle for 20 ~ 30 minutes in order to circulate the oil through the compressor.
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
265 cc
Replacement of Oil
1. Perform the oil circulation and stop the engine. Remove
the compressor on the vehicle.
2. Drain the oil at the position of the system line connection.
Notice
It may be difficult to discharge the oil when the
compressor is cold. At this time warm the compressor
(40 ~ 50°C) before discharging the oil.
Y220_10C029
A/C SYSTEM
REXTON SM - 2004.4