SSANGYONG Rexton 2004 Service Manual page 1126

10C-70
Intake Door Actuator
1. Disconnect the negative battery cable.
2. Remove the glove box.
3. Disconnect the intake door actuator connector.
4. Remove the screws at the mode control door actuator and heater/air distributor case.
5. Carefully remove the mode control door actuator.
6. Install in the reverse order of removal.
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
Mode Control Door Actuator
1. Disconnect the negative battery cable.
2. Remove the knee bolster.
3. Disconnect the mode control door actuator connector.
4. Remove the screws at the mode control door actuator
and heater/air distributor case.
5. Carefully remove the mode control door actuator.
6. Install in the reverse order of removal.
Y220_10C087
Sun Sensor
1. Disconnect the connect and remove the sun sensor from
the instrument panel.
2. Install in the reverse order of removal.
Notice
Be careful not to drop the disconnected wiring
harness into the instrument panel when removing.
Y220_10C088
A/C SYSTEM
REXTON SM - 2004.4