Table of Contents
Advertisement
Safety messages
NOTICE
Read this manual before working with the product. For personal and system safety, and for optimum product performance,
ensure you thoroughly understand the contents before installing, using, or maintaining this product.
For technical assistance, contacts are listed below:
Customer Central
Technical support, quoting, and order-related questions.
•
United States - 1-800-999-9307 (7:00 am to 7:00 pm CST)
•
Asia Pacific- 65 777 8211
North American Response Center
Equipment service needs.
•
1-800-654-7768 (24 hours a day — includes Canada)
•
Outside of these areas, contact your local Emerson representative.
WARNING
Failure to follow safe installation and servicing guidelines could result in death or serious injury.
Ensure the transmitter is installed by qualified personnel and in accordance with applicable code of practice.
Inspection and maintenance of this equipment shall be carried out by suitably trained personnel, in accordance with the
applicable standards and code of practice.
Use the equipment only as specified in this manual. Failure to do so may impair the protection provided by the equipment.
Repair, e.g. substitution of components, etc. may jeopardize safety and is under no circumstances allowed.
WARNING
Process leaks could result in death or serious injury.
Handle the transmitter carefully.
Install and tighten process connectors before applying pressure.
Do not attempt to loosen or remove process connectors while the transmitter is in service.
WARNING
Physical access
Unauthorized personnel may potentially cause significant damage to and/or misconfiguration of end users' equipment. This could
be intentional or unintentional and needs to be protected against.
Physical security is an important part of any security program and fundamental to protecting your system. Restrict physical access
by unauthorized personnel to protect end users' assets. This is true for all systems used within the facility.
CAUTION
Hot surfaces
The transmitter and process seal may be hot at high process temperatures. Allow to cool before servicing.
2
Advertisement
Table of Contents
Troubleshooting
