Quick Start Guide June 2022 About this guide This guide provides instructions for mounting the extendable bracket. Safety messages WARNING Failure to follow safe installation and servicing guidelines could result in death or serious injury. Ensure only qualified personnel perform the installation. Bracket hole pattern Figure 1-1: Hole Pattern for Wall Mounting 3.23 (82)
Page 3
June 2022 Quick Start Guide Mount the extendable bracket Procedure 1. Mount the bracket on the pipe/wall. On pipe: 13 mm On wall: Quick Start Guide...
Page 4
Quick Start Guide June 2022 2. Mount the extendable arm. Do not fully tighten the screws at this stage. 3. Install and hand tighten the transmitter. Extendable mounting bracket...
Page 5
June 2022 Quick Start Guide 4. Connect the M12 cable. 5. Ensure the adjustable holder is properly aligned. Quick Start Guide...
Page 6
Quick Start Guide June 2022 6. Fold down the arm to a horizontal position. 7. Adjust the length of the arm as necessary. Then tighten the two screws. Extendable mounting bracket...
Page 7
June 2022 Quick Start Guide 8. Check that the bracket installation is level. To raise or lower the arm, adjust the two level screws. Then tighten the two nuts. 10 mm 9. Tighten the two screws. Quick Start Guide...