Table of Contents
Advertisement
Rear/Bottom Panel
HDMI cable holder
Secures the HDMI cable (Ø7 mm or less).
Close
Cable
SERIAL REMOTE RS-232C connector (D-
sub 9-pin, female)
The monitor can be operated according to
control commands sent from connected external
equipment.
REMOTE connector (Stereo mini jack)
The monitor can be operated partially by
connecting the optional Foot Switch FS-24.
SERIAL REMOTE connector (RJ-45)
The monitor can be operated according to
control commands sent from connected external
equipment.
Connect to the network by using a 10BASE-T/
100BASE-TX LAN cable (non-shielded type of 5 or
more category, optional).
Note
Consult with Sony qualified personnel at using
this connector.
Caution
For safety, do not connect the connector to
peripheral device wiring that might have
excessive voltage.
Follow the instructions for use for this port.
Note
The connection speed may be affected by the
network system. This unit does not guarantee
the communication speed or quality of 10BASE-
T/100BASE-TX.
DVI-D input/output connector (DVI-D)
input connector
Input connector of DVI Rev.1.0 applicable
digital signal.
output connector
Active through output connector of the DVI
digital signal.
The signal protected by HDCP
18
1)
is not output.
Advertisement
Table of Contents
