Table of Contents
Advertisement
181
0
(Equipotential) terminal
Connects the equipotential plug.
f) 'v (AC input) connector
Connects the supplied AC power cord.
Sony AC-120MD
Connect the DC connector of the separately sold AC
adaptor.
Connect the DC connector to the unit, then connect the
power cord of the AC adaptor.
To remove the DC connector, remove the power cord of
the AC adaptor, then remove the DC connector.
For the DC power supply, make sure to use the separately
sold AC adaptor, AC-120MD.
If another power supply is used, there is a risk of füe or
electric shock.
Rear/Bottom Panel
,&-
Slide the shutter and select an input terminal that
you want to use.
8
CE]
Caution
Warning
Location and Function of Parts and Controls
(DC input) connector
= �
0
& SV 2.0A (DC output) connector
Outputs 5 volts for connected external equipment.
0 IZI SERIAL REMOTE connector (RJ-45)
The monitor can be operated according to control
commands sent from connected external equipment.
Connect to the network by using a lOBASE-T /lO0BASE
TX LAN cable (non-shielded type of 5 or more category,
optional).
• For safety, do not connect the connector to peripheral
device wiring that might have excessive voltage.
Follow the instructions for use for this port.
• The connection speed may be affected by the network
system. This unit does not guarantee the
communication speed or quality of l0BASE-T /
lO0BASE-TX.
0 IZI SERIAL REMOTE RS-232C connector (D-sub
9-pin, female)
The monitor can be operated according to control
commands sent from connected external equipment.
f) -EJ SDI input connector (BNC type)
Input connector for serial digital component signals
1) Serial digital component signals are SMPTE ST 259
compliant (SD)/SMPTE ST 292-1 compliant (HD).
=
Caution
l) 2).
Advertisement
Table of Contents
