Rear/Bottom Panel; Power Switch - Sony LMD-2451W Operating Instructions Manual

DISPLAY" on page 68, "MARKER ENABLE" on page 70,
and "MULTI DISPLAY ENABLE" on page 71).
*9 The signal can only be selected in the main display (see
"SUB INPUT SELECT" on page 71).

Rear/Bottom Panel

4 5
qa
a Power switch
The power is turned on or off.
The monitor is turned on by pressing side ?.
b AC IN socket
Connect the supplied AC power cord.
c
DC 24V IN connector (LMD-2451W) /
24V connector (LMD-2051W) /
12V connector (LMD-1751W)
Plug the DC power supply to this connector to provide
power to the monitor.
LMD-2451W and LMD-2051W run on DC 24V, and
LMD-1751W runs on DC 12V.
Note
Be sure to connect to a power supply of the specified
voltage value.
d AUDIO L/R IN connectors (phono jack)
Connect to the audio outputs of a VCR or to an audio
mixer.
54
Location and Function of Parts and Controls
6 7 8 9 0
qs
*10 When a BKM-244CC is installed, closed captions are
displayed.
*11 When a BKM-250TG is installed, the signal is input.
1 2 3
– +
qd
qf qg qh qj
e COMPOSITE IN connector (BNC)
Input connector for composite signals.
f Y/C IN connector (4-pin mini-DIN)
Input connector for Y/C signals.
g G/Y IN connector (BNC)
Input connector for G of RGB signals and component Y
(luminance) signals.
h B/P
IN connector (BNC)
B
Input connector for B of RGB signals and P
difference) of component signals.
i R/P
IN connector (BNC)
R
Input connector for R of RGB signals and P
difference) of component signals.
j EXT SYNC IN/OUT (external sync) connectors
(BNC)
To use the external sync signal, press the function button
that EXT SYNC is assigned (F1 button at the factory
setting).
IN connector
qk
(blue color
B
(red color
R