Table of Contents
Advertisement
Submenu
Setting
Auto:
The format and scan mode are
displayed temporarily when the
content of Status Display is
changed.
On:
The format and scan mode are
always displayed.
Off:
The format and scan mode are not
displayed.
Notes
Even if "Status Display" is set to
"Auto" or "Off," the flip pattern is
always displayed.
For details about the signal format,
refer to no signal and incompatible
signal displays.
Input
No signal
Non compatible
signal (except for
DVI-D)
Non compatible
signal (DVI-D)
Language
You can select the menu or message
language from the following
languages.
English: English
Italiano: Italian
Deutsch: German
Русский: Russian
Power On Setting
Power On Mode
Select the setting when the monitor is
turned on from the following settings.
Last:
The setting when the monitor was
last turned off.
Default Setting:
The setting that is set in the default
setting.
User1 to 20:
The selected user setting.
Logo
When the power turns on, select from
among "On - 5sec," "On - 10sec," "On -
30sec," "On - 60sec," "On - 120sec,"
"Off."
Signal format
display
No Sync
Unknown
Out Of Range
: Chinese
: Japanese
: Spanish
: French
Submenu
Power Save
Energy Saving
Mode
Sleep Mode
Serial Remote
Serial Remote
Remote
Remote Mode
Ethernet Setting
28
Setting
You can select the energy saving mode
from the following options.
Off:
Turns the energy saving mode off.
Mode1:
Dims the backlight.
1)
Mode2
:
Stabilizes the backlight to a low
brightness state and stops the
rotation of the fan.
1) It stops the output of voltage from
the DC output connectors.
When the monitor reaches a higher
temperature, the fan rotates.
Sets the sleep mode to on or off. When
you set to "On," the monitor enters
into power saving mode by turning off
the backlight if there is no input signal
from the selected connector for more
than 1 minute.
Selects the using mode.
Off:
Disables the serial remote function.
RS-232C:
Controls this unit via RS-232C
command.
Ethernet:
Controls this unit via Ethernet
command.
Sets the remote function when the
REMOTE connector is connected to the
optional Foot Switch FS-24.
Off:
Disables the remote function.
Port:
Switches between PORT A and
PORT B.
When PORT A is selected, it is
switched to PORT B. When PORT B
is selected, it is switched to PORT A.
PIP/POP:
Switches between the single-image
display and multi-image display
(PIP1/PIP2/POP1/POP2).
Sets the Ethernet.
IP Address:
Sets the IP Address.
Subnet Mask:
Sets the Subnet Mask.
Default Gateway:
Sets "On" or "Off" of the Default
Gateway.
Address:
Sets the Default Gateway.
Save:
Saves the confirmed setting.
Cancel:
Returns to the previous setting
from the confirmed setting.
Advertisement
Table of Contents
