Zmotion ZMIO300 Series Hardware Manual page 43

iobase
Example
Matters need
attention
Grammar
NODE_IO (slot, node) = aiobase
Parameter List
aiobase
Example
NODE_AIO (0,0) = 32 ' Expanded AIO start number of Node 0 is 32
Matters need
attention
ZCAN expansion
If coupler uses ZCAN communication module, IO start numbers of input module
and output module and AIO start numbers of AD module and DA module are configured
through dial code switch. For the start number of dial code switch, please see ZCAN
communication module.
IO start number
NODE_IO (0,0) = 32
IO start number only can be set to multiples of 8, like, 0, 8, 16, etc. If
the IO start number is 30, which means it should be set as 24.
Firstly, check the controller status to know the local IO maximum
value of controller exactly, then use NODE_IO for avoid repetition. If
expanded IO number and local IO repeat, they become invalid
simultaneously, so it is not recommended.
NODE_AIO
slot Controller bus slot number
node Device number
AIO start number
Firstly, check the controller status to know the local AIO maximum
value of controller exactly, then use NODE_AIO for avoid repetition.
If expanded AIO number and local AIO repeat, they become invalid
simultaneously, so it is not recommended.
ZMIO300 Series Hardware Manual Version 1.8
Expanded input and output start
numbers are the same
' Expanded IO start number of Node 0 is 32
Expanded AD and DA start
numbers are the same
43
Default is 0
Start from 0, 0-