Zmotion ZMIO300 Series Hardware Manual page 34

9 AGND Current input negative pole
10 NC
11 I + Current input positive pole
12 V + Voltage input positive pole
13 V - Voltage input negative pole
14 SG
15 I + Current input positive pole
16 V + Voltage input positive pole
17 V - Voltage input negative pole
18 SG
19 E+24V
20 EGND
Terminal Wiring
(Please use tubular pre-insulated terminals and wire cable that is suitable to wire path
to do user terminal wiring)
→Cable production steps:
➢ Strip the cable insulation, the exposed copper part depends on the size of the tube-
type pre-insulated terminal.
➢ Pass the conductor part of the cable into the tubular pre-insulated terminal and
crimp it with a crimping pliers.
→Wire cable connection steps:
➢ Press the spring of the terminal to insert the cable with the tubular pre-insulated
terminal into the port.
➢ Loosen the spring of the terminal, pull the cable lightly to check whether the cable
is firmly connected.
Matters need attention
➢ When wiring the terminal cables, avoid being bundled with cables with strong
interference signals, such as power lines, and must be routed separately.
-
-
-
Power positive pole
Power negative pole
ZMIO300 Series Hardware Manual Version 1.8
Public current input negative pole
Reserved
Channel 2 current input positive pole
Channel 2 voltage input positive pole
Channel 2 voltage input negative pole
Safety ground / Shield layer
Channel 3 current input positive pole
Channel 3 voltage input positive pole
Channel 3 voltage input negative pole
Safety ground / Shield layer
24V power input positive pole
24V power input negative pole
34