Testing The Installation - Sun Microsystems StorEdge L11000 User Manual

2. Verify that the GUI state display indicates "System Off-line."
3. Verify that the cartridge handling mechanism (CHM) is empty by checking the
Overview screen on the GUI (see Chapter 3).
If there is a tape cartridge in the CHM, perform a Move command to place the
cartridge in an available bin.
4. Turn off the power switch located below the GUI.
5. Turn off CB1 on the AC power distribution assembly (or both assemblies if two
are present).
Note – Wait ten seconds before turning on the power switch again.

Testing the Installation

After you finish installing the library, perform the following operations to set up and
test the library:
Calibrate the library
Exercise the library
Issue SCSI commands from each of the host computers
For more information about the Calibrate Library and Exercise Library commands,
see Chapter 3. For more information about issuing SCSI commands from the host
computer, refer to the host computer operating system/application software
documentation.
44 Sun StorEdge L11000 User's Guide • September 1998