Table of Contents
Advertisement
Note – To move a cartridge from a tape drive, first issue an Unload Drive command
as explained in "Unloading a Drive" on page 68.
To Move a Cartridge
1. In the Operator screen, press the Move Cartridges button.
The Control: Move Cartridges screen appears with the Source input field active
(
).
FIGURE 4-7
Control: Move Cartridges Screen
FIGURE 4-7
1. Backspace Button. Use this button to erase a partial entry character by character.
2. Identify the source element of the cartridge to be moved. Proceed as follows:
a. Press the appropriate source element button (Storage Bin, Tape Drive, Load
Port, or Gripper).
When you select an element type, the range of addresses appears in the Range
display below the Destination text box.
b. Using the keypad, enter the address of the source element and then press the
Destination input field.
The source information appears in the Source text box and the Destination text
box becomes active.
1
Chapter 4
Operator Commands
67
Advertisement
Table of Contents
