Table of Contents
Advertisement
If you set up the library with multiple SCSI buses (see Appendix C), you can assign
the same number to two or more devices, provided each device is on a different SCSI
bus.
Note – Power must be recycled for the new SCSI ID number to become effective.
Configuring Library Options
The Configure Options command enables you to set the following:
Power-On State - Determines whether the library is on-line or in standby mode
when powered up.
Auto Clean - Enables the library to perform drive cleaning tasks automatically as
needed.
Retries - Causes the library to automatically retry a failed command before issuing
an error message.
Bar Code Labels - Turns bar code scanning on or off during inventory. It should be
disabled when the library contains cartridges that are not labeled.
Auto Inventory - Causes the library to perform an inventory whenever the library
is powered up.
Auto Load - Causes the library to automatically move cartridges in the load packs
to empty storage bins as soon as the load port door closes.
Temp. Detection - Enables or disables the over-temperature detection warning and
shutdown features of the library.
4/52 identity - Causes the library to return the same inquiry string as the
ACL 4/52 library.
Power-On Security - Determines the library security level when powered up.
For more information about these features, refer to the Sun StorEdge L11000 Software
Interface Guide.
To Configure a Library Option
1. In the Operator screen, press the Configure Options button.
The Configure: Options screen is displayed (
).
FIGURE 4-5
Chapter 4
Operator Commands
63
Advertisement
Table of Contents
