Program Entry/Exit - AMX SX16+ Instruction And Programming Manual

Entering Program Modes
Pushing buttons 15 and 16 simultaneously while
also pushing buttons 1 - 4, 10, or 11 puts an SX16+
into one of six program modes.
Exiting Program modes
After making any changes to or simply checking the
status of an SX16+, any program may be exited
with or without changes.
If changes were desired, exiting with change is
used.
Exit With Change
Press Buttons 15, 16 and 13 Simultaneously
If changes were made but may not be desired,
exiting without change returns to the previous
program before entering the program mode.
Exit Without Change
Press Buttons 15, 16 and 14 Simultaneously
AMX Reserves the right to alter specifications without notice at any time.
040-004-1072 7/88 AMX Corporation, 3000 Research Dr. Richardson, TX 75082
Program Entry / Exit Commands
The 'All Clear' Mode
It is possible to completely clear all 16 relay
channels of an SX16+ while in a particular mode.
This can be done by pressing a combination of
buttons WHILE IN that program mode.
All settings for ALL relays will be cleared in that one
SX16+, for that mode only. The rest of the system
will see the All Clear as an 'Exit' command and all
relays in all SX16+s will return to normal operation.
The All Clear or null status varies from mode to
mode
Cleared Status For Each Program Mode
Mode 1 (Momentary/ Latched) - All relays
momentary.
Mode 2 (Radio Address) - Not affected.
Mode 3 (Control Button to relay assignment) All
special assignments in that SX16+, are cancelled.
Natural assignments (by radio address) are
defaulted to.
Mode 4 (Mutually Exclusive Relay Sets) - All
Exclusive Sets are cancelled in that SX16+
including all stacked sets.
All other front panel programming modes are not
affected at this time by All Clear.
All Clear Command
Press Buttons 15, 16 and 12 Simultaneously
21
Page
800.222.0193