Cornelius Bubble Installation, Operation & Service Manual page 14

`
3. Open the front splash panel and find the air intake pipe from the fitting box. Similarly, pass
through the hole in the rear panel of the equipment. Connect the CO2 intake pipe at the front
end of the water tank. Connect the power supply, use the water valve nozzle to connect the
water tank drainage pipe to the water dripping tray, and stop the water filling. If conditions
permit, use ice water. First, the stainless steel nozzle jacket is unloaded by external rotation,
then the valve core is removed, the stainless steel water jacket in the fittings is taken out and
installed on the valve, the drip box is removed, the drainage pipe is pulled out from the lower
part of the equipment, the water plug is removed, and the water pipe is connected to the
pagoda pipe with the water jacket.
Connect the carbon dioxide pipe
Take out the drip tray Realese the soda water valve & internal parts
10 © 2019, Cornelius Inc