Akai Z4 User Manual page 84

76
Chapter 9—Using Q-Link
Use the JOG dial to select a parameter
6
When "Part" is selected, you can select parameters that are available to Program modu-
lation sources (e.g., Amplitude, Pan, Cutoff, and so on), EXT 1–8, or OFF. When
EXT 1–8 is selected, only the modulation destinations (for which EXT 1–8 are assigned
as the source) are affected.
In the case of FX, you can select the parameters of the FX type currently assigned to each
FX. See "Selecting FX Types" on page 79 for more information.
Press "RESET" to reset the parameters that are controlled by the selected Q-LINK to
their original values. Press "RESET ALL" to reset the parameters that are controlled by
all Q-LINKs to their original values.
You can specify how much control the Q-Link controls exert over the assigned parame-
ters on the CHANGE page.
7 Press "CHANGE."
The CHANGE page appears, as shown below.
8 Select the Replace/Offset parameter for the Q-Link control that you want
to configure, as shown in the example above.
9 Use the JOG dial to select either of the following options:
REPLACE:
that they ignore the parameter's original setting.
OFFSET:
original setting.
Select the first range parameter for the Q-Link control that you want to con-
10
figure, and use the JOG dial to set it, as shown in the example below.
If REPLACE is selected, you can specify the control range from –100 to +100. If the
range is set to, for example, "0>50", the minimum position of the Q-Link control (when
the control is turned all the way to the left) is 0, while the maximum position (when the
control is turned all the way to the right) is 50. With a setting of, for example, "100>0,"
the minimum position of the Q-Link control is 100, while the maximum position is 0.
If OFFSET is selected, you can specify the control range from –100 to +100. If the range
is set to, for example, "–25>+25", the minimum position of the Q-Link control is –25,
while the maximum position is +25. With a setting of, for example, "+25>–25," the min-
imum position of the Q-Link control is +25, while the maximum position is –25.
Z4/Z8 User Guide—Version 1.0
Adjustments made by using the Q-Link control are absolute, which means
Adjustments made by using the Q-Link control are relative to the parameter's