Renaming Samples; Copying Samples - Akai Z4 User Manual

46
Chapter 6—Editing Samples
The Stretch Quality window appears, as shown below.
Set the "Preset" and "Adjust" parameters as required.
7
The "Preset" and "Adjust" parameters are the same as those for the Pitch Shift function
(see page 35).
8 Press "DO IT."

Renaming Samples

You can rename the selected Sample as follows.
Select the Sample name in the upper-left corner of the TRIM, LOOP , or
1
REGION page, then press the WINDOW button.
The Sample window appears, as shown below.
Name:
dial to open the Name window. See "Entering Names" on page 17 for more information
on using the Name window.
Original note:
inal pitch.
Tune:
Rate:
Bits:
Size:

Copying Samples

Samples can be copied as follows.
1 While the Sample you wish to copy is selected for the "Name" parameter
in the Sample window (shown above), press "COPY."
The Copy Sample window appears, as shown below.
Sample:
New name:
window appears. See "Entering Names" on page 17 for more information.
2 Press "DO IT."
The Sample is copied.
Z4/Z8 User Guide—Version 1.0
This is the name of the selected Sample. To rename the Sample, rotate the JOG
This determines the note at which the selected Sample plays at its orig-
This allows you to fine-tune the pitch of the Sample in semitone and cent steps.
This is the sampling rate of the selected Sample.
This is the bit resolution of the selected Sample.
This is the size of the selected Sample in kilobytes.
This is the name of the selected Sample.
Enter a name for the new Sample here by rotating the JOG dial. The Name