Configuring Programs - Akai Z4 User Manual

Tagged Programs have a tick next to their name, as shown below.
To untag a Program, press and hold the SHIFT button, and then press "TAG" again. You
can untag all Programs by pressing "ALL CL." Programs can also be tagged on the Tag
List window, shown below, which is accessed by pressing "LIST."
Use the JOG dial or Up and Down CURSOR buttons to select Programs, and press
"TAG" to tag or untag the selected Program. Tagged Programs have a tick next to their
name. Press "ALL CL" to untag all tagged Programs.
Configuring Programs
Keygroup and Drum Programs can be configured as follows.
1 Press the PROGRAM button.
The PROGRAM button indicator lights up and the MAIN page appears.
2 Select the Program name, and then use the JOG dial to select a Program.
Select the parameters, and use the JOG dial to set them as required.
3
Monitor: (OMNI or MULTI) This parameter determines how the selected Program
responds to MIDI data in Program Mode. When this parameter is set to "OMNI," the Pro-
gram can be played via any MIDI Channel. When it is set to "MULTI," you can monitor
the currently-selected Multi.
Level:
(–60.0 to +6.0) This sets the output level of the Program.
Transpose:
Tune: (–36.00 to +36.00) This sets the pitch of the Program in semitone and cent steps.
Program No.
that will select the Program. When set to "OFF," the Program ignores MIDI Program
Change messages.
Pressing the WINDOW button while the "Program No" parameter is selected opens the
Program List window, shown below, which can be used to assign Program Change num-
bers to Programs.
(–36 to +36) This can be used to transpose incoming MIDI note messages.
(1–128 or OFF) This parameter determines the MIDI Program Change

Configuring Programs

Z4/Z8 User Guide—Version 1.0
49