Configuration Overview; Configuration Basics - Emerson Rosemount 3051P Reference Manual

Configuration
April 2020
2.5

Configuration overview

This section contains information on commissioning and tasks that should be performed
on the bench prior to installation, as well as tasks performed after installation as described
in Performing transmitter
Field Communicator, AMS Device Manager, and local operator interface (LOI) instructions
are given to perform configuration functions. For convenience, Field Communicator Fast
Key sequences are labeled "Fast Keys," and abbreviated LOI menus are provided for each
function below.
Full Field Communicator menu trees and Fast Key sequences are available in
Communicator menu trees and Fast
interface
2.6

Configuration basics

CAUTION
Set all transmitter hardware adjustments during commissioning to avoid exposing the
transmitter electronics to the plant environment after installation.
You can configure the transmitter either before or after installation. Configuring the
transmitter on the bench using either a Field Communicator, AMS Device Manager, or LOI
ensures all transmitter components are in working order prior to installation. Verify that
the security switch is set in the unlock position ( ) to proceed with configuration. See
Figure 4-2
2.6.1 Configuring on the bench
To configure on the bench, you will need a power supply and a Field Communicator, AMS
Device Manager, or local operator interface (LOI), option M4.
Wire equipment as shown in
resistance of at least 250 Ωs must be present between the transmitter and the power
supply; see
terminals labeled "COMM" on the terminal block.
14
tests.
(LOI).
for switch location.
Figure
Power supply for details. Connect the Field Communicator leads to the
Keys. LOI menu trees are available in
2-3. To ensure successful HART
Reference Manual
00809-0700-4001
Field
Local operator
®
communication, a
Emerson.com/Rosemount