Mercedes-Benz Sprinter Operating Instructions Manual page 131

If the electronic level control compressor is in dan-
ger of overheating, for example, due to repeated
raising or lowering within a short period, electronic
level control is deactivated. You can raise or lower
the vehicle level again after a few minutes.
Raising and lowering the vehicle level
Using the remote control
%
Certain special equipment enables other oper-
ation options:
Ambulance: raising the vehicle level above
R
the driving level (center position) is not
possible. Only the lowest position and the
driving level can be set.
Speed signal: in order to operate elec-
R
tronic level control, the parking brake must
not be applied. Electronic level control can
be operated manually up to 6.2 mph
(10 km/h). If this speed is exceeded, driv-
ing level will be set automatically.
30-minute run-on module: electronic level
R
control can be operated up to 30 minutes
after switching off the vehicle.
The remote control is located in a holder on the
B‑pillar on the driver's side. Remove the remote
control from the holder before use.
Electronic level control starts automatically if the
vehicle is switched on. Operation is only possible
after the parking brake has been applied.
Electronic level control performs a self-check regu-
larly when it is activated and while in use. Indicator
lamp 7 on the remote control lights up for about
one second when you switch on the vehicle.
There is a malfunction if indicator lamp
behaves in the following ways:
the indicator lamp does not light up when you
R
switch on the vehicle
or
the indicator lamp then lights up again or
R
flashes
In addition, a warning tone is emitted from the
remote control for approximately 30 seconds. The
malfunction that has been detected can be shown
using the indicator lamps (signaling of malfunction
codes).
Park the vehicle safely and leave it switched
#
on.
Apply the parking brake.
#
To raise or lower the vehicle level: press and
#
hold button
reaches the required height.
The indicator lamp on button
as long as the vehicle level is being changed.
When the vehicle level has been set, the indi-
cator lamp on button
To lower automatically: briefly press button 5.
#
Electronic level control automatically lowers
the vehicle to the next lower position:
From the highest position to driving level
R
From driving level to the lowest position
R
The indicator lamp on button
long as the vehicle level is being changed.
When the vehicle level has been set, the indi-
cator lamp on button
%
By pressing button
the original position will be reset.
To raise automatically: briefly press button 4.
#
Electronic level control automatically raises the
vehicle to the next higher position:
From the lowest position to driving level
R
From driving level to the highest position
R
The indicator lamp on button
long as the vehicle level is being changed.
When the vehicle level has been set, the indi-
cator lamp on button
%
By pressing button
the original position will be reset.
To raise or lower automatically to driving level
#
(center position): press and hold button 6.
Electronic level control automatically raises or
lowers the vehicle to driving level.
7
To save the set vehicle level: set the required
#
vehicle level.
Press and hold button
#
a warning tone.
The vehicle level set has been saved on corre-
sponding button
Driving and parking 129
4 or 5 until the vehicle level
4 or 5 flashes
4 or 5 lights up.
5 flashes as
5 lights up.
4 during the movement,
4 flashes as
4 lights up.
5
during the movement,
1 or 2 until you hear
1 or 2.