Mercedes-Benz Sprinter Operating Instructions Manual page 45

Top Tether anchorages 1 are located on the back
of the respective rear bench seat on the bench
seat legs.
If necessary, move the head restraint upwards
#
( page 77).
/
Install the ISOFIX child restraint system with
#
Top Tether. Comply with the child restraint sys-
tem manufacturer's installation instructions.
3
Guide Top Tether belt
#
restraint between the two head restraint bars.
Hook Top Tether hook 2
#
1
anchorage without twisting.
Tension Top Tether belt 3. Comply with the
#
child restraint system manufacturer's installa-
tion instructions.
If necessary, slide the head restraint down-
#
wards ( / page 77). Make sure that you do
not interfere with the correct routing of Top
Tether belt 3.
Securing the child restraint system with the seat
belt
▌Securing the child restraint system with the seat
belt on the rear seat
When installing a belt-secured child restraint sys-
tem, observe the following:
O Always observe the manufacturer's installa-
O When using a baby car seat in weight cate-
O When using a forward-facing child restraint
O The backrest of the forward-facing child
O For certain child restraint systems in weight
O The child restraint system must not be put
under the head
O The child restraint system must not be put
into Top Tether
O Make sure that the child's feet do not touch
The seat belts on the following seats are equipped
with a child seat safety feature:
R
R
When activated, the child seat safety feature
ensures that the seat belts of the co-driver seat
and rear seats do not slacken once the child
restraint system is secured (
Occupant safety
tion and operating instructions for the child
restraint system used.
gory 0/0+ and a rearward-facing child
restraint system in weight category I on a
rear seat: adjust the front seat so that the
seat does not touch the child restraint sys-
tem.
system in weight category I: remove the head
restraint from the respective seat, if possible.
After the child restraint system has been
removed, replace the head restraint immedi-
ately and adjust all head restraints correctly.
restraint system must, as far as possible, be
resting on the seat backrest of the rear seat.
category II or III, there may be restrictions on
the maximum size setting, e.g. due to possible
contact with the roof.
under strain between the roof and the seat
cushion and/or be installed facing the wrong
direction. Where possible, adjust the seat
cushion inclination accordingly.
under strain by the head restraint. Adjust the
head restraints as appropriate.
the front seat. If necessary, move the front
seat slightly forwards.
Co-driver seat
Rear seats
/
43
page 41).