Mercedes-Benz Sprinter Operating Instructions Manual page 100

Light and vision
98
Digital image noise may occur on the display under
certain circumstances in unfavorable ambient
light.
Certain types of sunlight, e.g. sun low on the hori-
zon or light from another intense light source, can
reduce the display's contrast and cause it to
become too bright. In such situations, objects on
the display may be obscured or difficult to see. In
these cases, be particularly careful and adapt your
driving style accordingly.
Drivers must always wear the necessary personal
visual aids required for them to drive a vehicle.
Drivers with presbyopia (age-related long-sighted-
ness) should, if necessary, wear visual aids with
multifocal lenses to be sufficiently able to see traf-
fic including via the displays.
%
If the camera on top of the roof at the rear is
dirty, the image may be impaired. In this case,
clean the camera manually with a damp cloth.
Observe the notes on cleaning the digital
inside rearview mirror (
/
To use the standard inside rearview mirror:
#
move the switch to position 1.
To use the display: move the switch to position
#
2.
Adjusting the display brightness
%
The digital inside rearview mirror is equipped
with light sensors on the front and back and
automatically adjusts the brightness of the dis-
play to the ambient light. Do not cover the
light sensors, e.g. with a sticker.
Press menu button 3 once.
#
Press button 4 to reduce the display bright-
#
ness.
or
Press button 5 to increase the display bright-
#
ness.
Adjusting the angle of the camera
Press menu button 3 twice.
#
Press button 4 to move the angle down-
#
wards.
or
Press button 5 to move the angle upwards.
#
Activating and deactivating the rear view camera
image
The vehicle may be equipped with a rear view cam-
era with image in the inside rearview mirror.
#
#
Error mode of the digital inside rearview mirror
If a system error occurs, e.g. if the camera fails, a
crossed-out camera will appear at the top left of
the display and no camera image will be visible in
the mirror.
#
If the vehicle is equipped with a rear view camera
with image in the inside rearview mirror and a sys-
tem error occurs, a crossed out camera with the
number 2 will appear on the left side of the display.
In this case, no camera image is available for
maneuvering.
Setting anti-glare mode for the inside rearview mir-
page 223).
ror
#
To activate, put the vehicle in reverse gear or
press button 5.
To deactivate, take the vehicle out of reverse
gear or press button 5 again.
Switch to the standard inside rearview mirror if
there is a system error.
Fold anti-glare lever 1 in the direction of the
arrow.