Table of Contents
Advertisement
14.3 Printer output
The printer allows various parameters to be recorded. There are 3 different kinds of message:
- Standard message
- Code message
- Fault message
14.3.1 Standard message:
Here a record opf all measured values is printed out in dependence on the sending interval.
Such a complete dats set is also printed out during NONSTOP operation.
Print out:
e.g.:
TC on UV off
LF1= 16.130 MΩxcm
LF2=
Temp.= 11.5 °C
14.3.2 Code message:
Whenever a code number is entered in the controls and confirmed with the Enter-key, then the
code input is immediately printed out.
For code identification, see the „Assignment Table for code numbers allowing the system to be
unlocked".
Print-out:
e.g.:
14.3.3 Fault message:
Should a fault message be shown in the display, e.g. the ultrapure water limiting value, then the
fault message is printed out at the end of the sending interval.
Print-out:
e.g.:
36
01.06.07 09:39
LabTower AFT
S.No.
9999/04
0.109 MΩxcm
01.03.07 10:17
LabTower AFT
S.No.
9999/04
Code 0001
01.03.07 16:15
LabTower AFT
S.No.
9999/04
Lim.value.ultrapure
Thermo Scientific Barnstead LabTower AFT
Pure water system
Advertisement
Table of Contents
