Table of Contents
Advertisement
6.3.2. Procedure A2: Electrode support.
• Switch off high voltage,
• Step 1: Manually unscrew the nozzle nut then
remove the deflector.
• Step 2: Remove the electrode support.
• Step 3: Clean the electrode support with compressed
air and also the deflector
Make sure that there is no accumulation of powder.
• Step 4: Clean the powder passage duct by blowing
with compressed air.
• Step 5: Before reassembling the electrode support,
clean the electrical contact with compressed air
located in the gun.
Check the condition of the O-rings, replace them if
necessary.
25
DRT7132
D - 2022 /09
Member of Exel group
Advertisement
Table of Contents
