Exit P Parameter Setting; C Parameter Setting - KUNTENG KT-LCD10YN User Manual

ELECTRIC BICYCLE METER KT—LCD10YN Product User Manual
P5 is power monitoring setting, when P5 setting is 0, the power monitoring is the
"real-time voltage" mode. Namely, it is the method to determine the battery capacity
based on real-time battery voltage. When P5 equals to a specified parameter, the power
monitoring is the "smart power" mode (this parameter is determined by the battery
characteristics, ordinary 24V lithium is generally is 4-11, 36V lithium is between 5_15). P5
setting ranges from 0-40, press
After finishing P5 parameter setting, press
values, and then P5 parameter column stops flashing. Press
meter re-enter P1 parameter setting interface. Or hold
seconds to exit P parameter setting environment and return to the display 1.
○

Exit P Parameter Setting

Among the five P parameter settings, when each parameter setting is completed, if
hold button (SW) for about 2 seconds, all can exit the setting environment and
return to display 1, meanwhile, the current set parameters would be saved.
Under each parameter setting interface, if there's no button operation on the meter for
more than 1 minute, and then the meter will automatically return to display 1, and the
original set parameters will be saved.

C Parameter Setting

After finishing P5 parameter setting, P5 parameter column stops flashing. Within 1
minute after stopping flashing, hold
about 2 seconds to enter C parameter setting environment.
P5 parameter setting interface
button (UP) or
button (UP) and
- 22 -
button (DOWN) for selection.
button (SW) to save current set the
button (SW) again, the
button (SW) for about 2
button (DOWN) for