P Parameter Setting; P1 Motor Characteristic Parameter Setting - KUNTENG KT-LCD10YN User Manual

ELECTRIC BICYCLE METER KT—LCD10YN Product User Manual
Among the three general project settings, after each setting is completed, if hold
button (SW) long for about 2 seconds, all can exit the setting environment and return to
display 1, meanwhile, the current set parameters are saved.
Under each setting interface, if there's no button operation on the meter for more than
1 minute, and then the meter will automatically return to display 1, and the original set
parameters will be saved.

P Parameter Setting

After finishing metric/imperial unit settings, the speed and mileage units stop flashing.
Within one minute after stopping flashing, hold
(DOWN) simultaneously for about 2 seconds to enter P parameter setting environment.
○

P1 Motor Characteristic Parameter Setting

P1 is motor characteristic parameter setting, P1 = motor gear reduction ratio× number
of rotor magnet pieces, just rounding if there's any decimal.
After entering P parameter setting environment, the first is to set P1parameter, P1
parameter column flashes. P1 setting ranges between1-255, press
button (DOWN) for selection.
Under P1 parameter setting interface, if there's no button operation on the
meter for more than 1 minute, and then the meter will automatically return to display
1, and the original set parameter will be saved.
After finishing P1 parameter setting, Press
and enter P2 parameter setting interface.
P1 parameter setting interface
- 19 -
button (UP) and
button to save the current set values
button
button (UP) or