Table of Contents
Advertisement
Energy efficiency class according to EN 60350-1
The energy efficiency class is determined in accordance with EN 60350-1.
Energy efficiency class: A+
Please observe the following when conducting testing:
- Testing is undertaken using the
- Select the
Lighting
- Only accessories that are required for testing should be in the oven compart-
ment during tests. Do not use any other available accessories such as FlexiClip
runners.
- The thermocouples must be inserted through the door seal for testing purposes.
To do this, pull the door seal out of its groove and pierce it in two places. Insert
the thermocouples through the two holes in the door seal. Then press the door
seal securely into the groove so that it is installed smoothly and evenly all the
way round.
- Next, remove the filter in the floor of the oven compartment and pour water into
the drain until you can see the surface of the water.
- An important pre-condition for determining the energy efficiency class is that the
door is tightly shut during testing.
Depending on the measurement devices used, the functioning of the door seal
can be affected to a greater or lesser extent. This has a negative impact on the
test results.
Eco Fan heat
|
"On" for 15 seconds
Note for test institutes
operating mode.
setting (see "Settings" – "Lighting").
173
Advertisement
Table of Contents
