Table of Contents
Advertisement
Problem
F138
F196
"HydroClean" continued
pears when the ma-
chine is switched on.
A message not listed in
this table is appearing
on the display.
Cause and remedy
The combination steam oven is leaking. Water has
run into the floor tray.
Switch the combination steam oven off and back
on again.
If the fault message appears again, contact the
Miele Customer Service Department.
There is a fault.
Switch the combination steam oven off and back
on again.
The filter in the floor of the oven compartment is not
inserted.
Switch the combination steam oven off.
Insert the floor filter.
Switch the combination steam oven back on
again.
If the fault message appears again, contact the
Miele Customer Service Department.
ap-
The cleaning process has been cancelled due to a
power cut or because the appliance has been
switched off.
The combination steam oven automatically performs
the wash and drying phase once it is switched back
on to remove any cleaning agent residues. This pro-
cess takes approx. 1 hour 30 minutes. After a cancel-
lation during the drying phase, the process takes ap-
prox. 30 minutes.
Normal operation of the combination steam oven is
only possible once this has been completed.
Follow the instructions on the display.
Note that the cleaning result is not optimal.
There is an electronic module fault.
Disconnect the power supply to the combination
steam oven for approx. 1 minute.
If the problem persists after the power supply has
been restored, please contact the Miele Customer
Service Department.
Problem solving guide
153
Advertisement
Table of Contents
