Taiwan Commate Computer Inc. PV-DDR User Manual page 48

(D: is the drive where CD Driver disk has been inserted)
2. Executing Windows NT Setup. When Setup start searching for a Network
Adapter, click " select from list " button.
3. Click "Have Disk..." button from Select Network Adapter dialog box.
4. The Insert Disk dialog box will be appeared. Type the correct drive and path
to load LAN driver. ( For example: C:\NTDRV, then click on " OK "
button. Note: C:\NTDRV is the location where LAN driver for NT)
5. The PCI 10/100Mb Fast Ethernet Adapter will be shown on list. Click on "
OK " button.
6. Select " Next " button to continue Setup.
7. You must answer a few more questions to continue Setup.
8. Restarting your system you will acquire network service.
(2). If you setup ACR LAN card after Windows NT was installed:
1. Please copy LAN driver for NT to your HDD first.
For example: copy D:\VIA\ACR-LAN\WNT40\*.* C:\NTDRV or
copy D:\VIA\ACR-LAN\WNT40\*.* A:\NTDRV or
(D: is the drive where CD Driver disk has been inserted)
2. Open " Control Panel " -> " Network ", click " Yes " button to setup
Network configuration.
3. Check the box on " Wired to the network " item then click " Next " button.
4. Click " select from list... " button then select " Have Disk..." button from
Select Network Adapter dialog box.
5. The Insert Disk dialog box will be appeared. Type the correct drive and path
to load LAN driver. ( For example: C:\NTDRV, then click on " OK "
button. Note: C:\NTDRV is the location where LAN driver for NT)
6. The PCI 10/100Mb Fast Ethernet Adapter will be shown on list. Click on "
OK " button.