Taiwan Commate Computer Inc. PV-DDR User Manual page 39

3.7.2 Reset Configuration Data
In case a conflict occurs after you assign the IRQs or after you configure
your system, you can enable this function to allow your system to
automatically reset your configuration and reassign the IRQs, DMAs, and
I/O address.
3.7.3 Resources Controlled By
Default setting is "Auto (ESCD) ". This setting allows the BIOS to self
detect setting and Plug-and-Play devices during start up. The user can
select and configure IRQs under "Manual" mode.
3.7.4 IRQ Resources
CMOS Setup Utility - Copyright ( C ) 1984 - 2001 Award Software
IRQ-3 assigned to
IRQ-4 assigned to
IRQ-5 assigned to
IRQ-7 assigned to
IRQ-9 assigned to
IRQ-10 assigned to
IRQ-11 assigned to
IRQ-12 assigned to
IRQ-14 assigned to
IRQ-15 assigned to
Exit F1 : General Help
Optimized Defaults
3.7.5 IRQ-xx assigned to
If your ISA card is not PnP compatible and requires a special IRQ to
support its function, set the selected IRQ-x assigned to : "Reserved". This
setting informs the PnP BIOS to reserve the selected IRQ for the installed
legacy ISA card.
3.7.6 PCI/VGA Palette Snoop
IRQ Resources
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
¯ ® ¬: Move
Enter : Select
F5 : Previous Value
Item Help
Menu Level >
Legacy ISA for
devices
compliant with the
original PC AT bus
Specification, PCI/ISA
PnP for devices
Compliant with the
Plug and Play standard
Whether designed for
PCI or ISA bus
architecture
+/-/PU/PD : Value F10 : Save ESC :
F6 : Fail-Safe Defaults F7 :