Ending The Process Data Acquisition - Sartorius Flexsafe Pro Operating Instructions Manual

Procedure
Slowly pull the device away from the Palletank
t
guide rollers are at the end of the guide rails of the Palletank
The device must roll away over the 2 rolling elements on the guide rails
of the Palletank for Mixing.
®
Pull the handle upwards slightly so that the rear guide rollers glide
t
downwards from the guide rails of the Palletank
Continue to slowly pull the device away from the Palletank
t
until the front guide rollers are at the end of the guide rails of the
Palletank for mixing. The device must roll away over the 2 rolling
®
elements on the guide rails of the Palletank
Press the handle downwards slightly so that the front guide rollers glide
t
from the guide rails of the Palletank
If the device was used at a lower temperature than the temperature at
t
the installation site where the device is intended to be used next: Accli-
matize the device (see Chapter "6.2", Page31).
WARNING Risk of injury from power supply when not in use! If the
t
device is temporarily not in use: Switch off the device. Disconnect the
power supply at the installation site and secure the power supply cable
to the device's cable reel.

8.13 Ending the Process Data Acquisition

Requirements
The mixing process is complete.
Procedure
Remove the USB stick from the device.
t
Seal the connection with the cover cap.
t
Operating Instructions Flexsafe
Operation
for mixing until the rear
®
®
for Mixing.
®
for mixing
®
for Mixing.
®
for Mixing.
®
Pro Mixer Drive Unit
®
for mixing.
47