14 Serial Trigger and Decode
14.1 Overview
The SDS6000L supports serial bus trigger and decode on the following serial bus protocols: I2C, SPI,
UART, CAN, LIN, FlexRay, CAN FD, I2S, MIL-STD-1553B, SENT, and Manchester.
Click the trigger descriptor box, and then select the Type as Serial in the trigger dialog box to
set the serial trigger:
A. Select the type as Serial
B. Select the serial bus protocol
C. Set the signal, including the mapping
relation between channels and bus
signals, and the thresholds
D. Trigger setting
E. Zone setting
i n t . s i g l e n t . c o m
SDS6000L User Manual
1 1 5