Serial Trigger And Decode; Overview - SIGLENT SDS5000X Series User Manual

SDS5000X Series Digital Oscilloscope User Manual

16 Serial Trigger and Decode

16.1 Overview

The SDS5000X supports serial bus trigger and decode on the following serial
bus protocols: I2C, SPI, UART, CAN, and LIN.
Press the Setup button on the front panel or touch the trigger descriptor box,
and then select the Type as Serial in the trigger dialog box to set serial trigger:
A. Select the type as Serial
B. Select the serial bus protocol
C. Set the signal, including the mapping
relation between channels and bus
signals, and the thresholds
D. Trigger setting
Press the Decode button or touch the Analysis>Decode to turn on the serial
decode dialog box:
1 0 9 / 2 3 6
W W W. S I G L E N T. C O M