Chery A21 2005 Service Manual page 125

CHERY A520 SERVICE MANUAL
(2) Loosen the locknut of right steering tie
rod and rubber sleeve clamp, and screw
down the toe-in adjusting lever to
regulate the length as per requirements
until it reaches the specified numerical
value.
(3) Fasten the locknuts, reinstall the rubber
sleeve clamp, and check whether the
locknut is fastened and the sheath is at
the proper position.
(4) After the front wheel toe-in is well
adjusted, you should check whether the
steering wheel is horizontal or not.
Otherwise, you should loosen the
locknuts of steering wheel to regulate it
to the horizontal position and fasten the
locknuts to meet the torque requirement
(30±3Nm).
PDF created with pdfFactory Pro trial version
44
www.pdffactory.com
CHASSIS