Chery A21 2005 Service Manual page 145

CHERY A520 SERVICE MANUAL
I. DISASSEMBLY AND ASSEMBLY OF
REAR VIBRATION DAMPER
Disassembly sequence:
1. Open the trunk lid; dismount the side
enclosure to expose the bolts connecting
rear strut assembly and vehicle body.
Dismount the two connecting bolts.
Mounting torque: 50±10 Nm.
2. Uplift the car. Dismount the bolts
connecting the lower control arm and
car
damping spring has a very strong
elasticity, it is very difficult to dismount
the fixed bolts of the lower part of strut
assembly due to the influence of the
spring force. Therefore, you should
firstly dismount the bolts connecting the
rear lower control arm and vehicle body
in order to reduce the bearing force of
coil
100—120Nm.
3. Dismount the bolts connecting rear strut
and lower oscillating arm. Mounting
torque: 80±5 Nm
4. Remove the rear strut assembly.
Assembly sequence:
1. Assemble the rear vibration damper
according to the reverse sequence of
disassembly.
2. Precautions:
① After assembly, all bolts must be
fastened up to specified torques.
② Please check the four wheel alignment
parameters after assembly.
PDF created with pdfFactory Pro trial version
body. Note: Since the helical
spring. Mounting torque:
64
www.pdffactory.com
CHASSIS